Fuel Pipes - RHS outer

Added the 2nd fuel pipe that runs alongside the 1st. This one is slight trickier as the bends aren't simple like the 1st. I tried to make a bit of a gap as it changes from the lowered part of the floor to under the footwell panel. This was so that I could run the front to rear brake pipe between.

The picture below show as I was starting to fit the brake pipe:



At this stage I was still using the Ikea M4 bolts to temporarily hold the P clips in place. I wasn't sure if I would need to remove the fuel pipes to drill the holes for the brake pipe fixings.




I also straightened out the bends on the 1st pipe so it ran along the edge of the chassis strut.