Below is Martin demonstrating how much force is needed to pull the rivet:
and here is the finished panel:
Also drilled and riveted the passenger bulkhead:
Thursday, 24 July 2008
Fitting body panels - Riveting
Riveted the LH tunnel side and the LH bulkhead panel. I wasn't sure how much silicone sealant to use but the natural rate it came out of the nozzle seemed to be about right with a tiny amount being squeezed out of the edge. Luckily I recruited a couple of friends to help as after a few rivets your hands get sore.
Below is Martin demonstrating how much force is needed to pull the rivet:
and here is the finished panel:
Also drilled and riveted the passenger bulkhead:
Below is Martin demonstrating how much force is needed to pull the rivet:
and here is the finished panel:
Also drilled and riveted the passenger bulkhead:
Subscribe to:
Post Comments (Atom)
Posts
No comments:
Post a Comment