Fillet adjustment & sealing windscreen

This was a really fiddly job. It took ages to get a good fit of the fillet that goes at the bottom of the screen. It needed at lot of very careful Dremel work removing tiny amounts at a time to get a good fit at the edges. I used a thin piece of paper to identify the high spots again and again. Eventually I was happy and so we could mastic in place.

I had to put some packing under the thin end of the wedge shaped spacers to get the right angle:

There is quite a big gap in the centre under the windscreen. All you can do is fill it with mastic. Lots and lots of mastic: